close
Auping
English
Auping
clear
search
Smart Base

Installation Smart Base

Installation Smart Base

On this page we help you install the Auping Smart Base.

Installation

New remote

Quick Start Guide

Installation

1. Unpack the Hive (white sticker) and, if included, the Drone (green) or Extension control box (yellow).


2. Put the control box on the mesh base and connect the power and synchronous cables.


3. Put the Hive into pairing mode by pressing the Pair button once briefly. A short beep confirms that the Hive is in pairing mode.


4. Put one remote into pairing mode by pressing and holding the Pair button on the remote for 3 seconds until the light flashes blue. The remote is paired when you hear a long beep and the light turns white.


5. To connect a second remote control, press the Pair button on the second remote control and hold for 3 seconds. 


6. Now press the Pair button on the previously paired remote control. If you hear a short beep then a long beep, the remote is paired and the light turns white.

7. Both remotes are now paired and ready to use.

8. Open the Auping Connect app on your phone and complete the onboarding process.

9. Your Auping Smart Base is ready for use.

Note: you can use the remotes to switch bed sides by pressing and holding the left and right memory buttons at the same time for 3 seconds until the light flashes green as confirmation. Each time you do this, the remote will switch between control bed side A, control bed side B, or control bed sides A+B.

This mode is not visible on the remote, but you can test it by operating the bed.
 

New remote

The new Smart Base also comes with a new remote control. It is equipped with smart technology.

bed control

Use the top row of buttons to adjust the movable parts up.
Use the bottom row of buttons to adjust the movable parts downwards.
Use the top large knob in the middle to adjust all parts up at the same time. Use the bottom large knob in the middle to adjust all parts downwards at the same time

Operate both halves of the bed
You can also operate your partner's bed half with the remote control. Press and hold the outer memory buttons for 3 seconds to switch sides of the bed. The remote will flash green three times after this action.

The controls go from bed half A to bed half B and then to A and B. You can then adjust both bed halves synchronously.

three preferred modes
You can program three preferred modes via the remote control. When you have found the position you want to save, hold down 1 of the 3 'dots' buttons for 3 seconds. The LED screen will then flash green 3x.
If you have saved several favorite positions, you can switch positions with 1 push of a button.

LED screen
By means of an LED screen behind the buttons, the new remote control provides guidance during daily use. You can encounter the following colors;

Blue: If the remote has not yet been paired, the LED screen will flash blue.
When the remote control is connected to a Smart Base, the LED screen turns blue.
White: When the remote control is in active mode, the LED screen turns white.
Green: When you program a preferred position or switch sides of the bed, the LED screen flashes green 3 times.
Orange: When the remote control is set to child lock, the LED screen turns orange when a button is pressed.